LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2008 >> Milan Base, 3.0 1, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 458 (Windows And Glass -- F250-F550 Super Duty) >> Removal And Installation >> Window Regulator and Motor - Rear >> Installation

Window Regulator and Motor - Rear: Installation

WARNING: This page is about a different car, the 2006 Ford Pickup, 2006 Ford F550 Super Duty, 2006 Ford F450 Super Duty, and 2006 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

    All vehicles 

    NOTE: Left side shown, right side similar.
    Fig 1: Installing Left Cable End Into Sliding Window Trough
    G04646292
  1. Install the left cable end into the sliding window trough.
  2. Install the left transition block on the cable end.
    Fig 2: Installing Left Transition Block On Cable End
    G04646293
  3. Install the left transition block in the rear sliding window trough.
    Fig 3: Locating Rear Sliding Window Trough
    G03925737
  4. Install the left-hand cable swag into the rear sliding window.
    Fig 4: Locating Left-Hand Cable Swag Into Rear Sliding Window
    G04646295
  5. Repeat Steps  1 through  4 for the right side.

    6. SuperCab vehicles 

  6. Install the rear corner trim panels. For additional information, refer to INTERIOR TRIM AND ORNAMENTATION .

    7. Regular and Crew Cab vehicles 

  7. Install the rear trim panel. For additional information, refer to INTERIOR TRIM AND ORNAMENTATION .
scientia non olet · About LEMON Manuals