Turbine Shaft Speed (TSS) Sensor And Intermediate Shaft Speed Sensor: Installation

WARNING: This page is about a different car, the 2006 Ford Pickup, 2006 Ford F550 Super Duty, 2006 Ford F450 Super Duty, and 2006 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

Install the TSS and intermediate shaft combination speed sensor.
1. Lubricate the O-ring with clean automatic transmission fluid and install the TSS and intermediate shaft combination speed sensor.
2. Install the bolt.
  - Tighten to 9 Nm (80 lb-in).
    
    Fig 1: Identifying Intermediate Shaft Combination Speed Sensor
    Courtesy of FORD MOTOR CO.
Connect the TSS and intermediate shaft combination speed sensor electrical connector.

Fig 2: Identifying Intermediate Shaft And Turbine Shaft Combination Speed Sensor Electrical Connector
Courtesy of FORD MOTOR CO.
Raise the transmission into position.
Position the crossmember to the transmission insulator and retainer, and loosely install the nut.

Fig 3: Locating Crossmember To Transmission Mount Nut
Courtesy of FORD MOTOR CO.
Install the LH crossmember bolts.
- Tighten to 81 Nm (60 lb-ft).
  
  Fig 4: Locating LH Crossmember Bolts
  Courtesy of FORD MOTOR CO.
Install the RH crossmember bolts.
- Tighten to 81 Nm (60 lb-ft).
  
  Fig 5: Identifying RH Crossmember Bolts And Nuts
  Courtesy of FORD MOTOR CO.
Install the bracket and loosely install the bolts.
1. Install the bracket.
2. Loosely install the bolts.
  
  Fig 6: Identifying Bracket Bolts
  Courtesy of FORD MOTOR CO.
Tighten the RH crossmember bolts.
- Tighten to 81 Nm (60 lb-ft).
  
  Fig 7: Identifying RH Crossmember Bolts
  Courtesy of FORD MOTOR CO.
Tighten the transmission insulator and retainer nuts.
- Tighten to 103 Nm (76 lb-ft).
  
  Fig 8: Identifying Transmission Support Insulator Nuts
  Courtesy of FORD MOTOR CO.
Install the wire harness and install the 2 retaining clips to the rear of the crossmember.

Fig 9: Locating Wire Harness At Rear Of Crossmember
Courtesy of FORD MOTOR CO.