LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2008 >> Milan Base, 3.0 1, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 453 (Engine System-General Information - F250-F550 Super Duty (Gasoline)) >> General Procedures >> Cylinder Block Core Plug Replacement >> Notes

Cylinder Block Core Plug Replacement: Notes

WARNING: This page is about a different car, the 2006 Ford Pickup, 2006 Ford F550 Super Duty, 2006 Ford F450 Super Duty, and 2006 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
SPECIAL TOOL CHART

G04646826
 Slide Hammer
100-001 (T50T-100-A)
MATERIAL SPECIFICATION

Item Specification
Threadlock 262 TA-26 or equivalent WSK-M2G351-A6
  1. Use a slide hammer or tools suitable to remove the cylinder block core plug.
    Fig 1: Removing Cylinder Block Core Plug Using Slide Hammer
    G03885062Courtesy of FORD MOTOR CO.
  2. Inspect the cylinder block plug bore for any damage that would interfere with the correct sealing of the plug. If the cylinder block plug bore is damaged, bore for the next oversize plug.
    3. NOTE: Oversize plugs are identified by the OS stamped in the flat located on the cup side of the plug.
  3. Coat the cylinder block core plug and bore lightly with Threadlock 262 and install the cylinder block core plug.
scientia non olet · About LEMON Manuals