Removal and Installation

WARNING: This page is about a different car, the 2006 Ford Pickup, 2006 Ford F550 Super Duty, 2006 Ford F450 Super Duty, and 2006 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

Remove the extension duct.
Remove the panel/defrost door vacuum control motor.
1. Disconnect the vacuum line.
2. Remove the pushnut.
3. Remove the screws.
4. Remove the panel/defrost door vacuum control motor.
  
  Fig 1: Identifying Panel/Defrost Door Vacuum Control Motor Components
  Courtesy of FORD MOTOR CO.
To install, reverse the removal procedure.
- Install a new pushnut.