LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2008 >> Milan Base, 3.0 1, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 451 (HVAC Control System - F250-F550 Super Duty) >> Removal And Installation >> Vacuum Control Motor - Air Inlet Door >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2006 Ford Pickup, 2006 Ford F550 Super Duty, 2006 Ford F450 Super Duty, and 2006 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
    CAUTION: Do not attempt to bend any part of the lever. It is brittle and will break.
  1. Remove the air inlet door vacuum control motor.
    1. Disconnect the vacuum line.
    2. Remove the screws.
    3. Rotate the vacuum control motor to disengage the lever and remove the air inlet door vacuum control motor.
      Fig 1: Rotating Vacuum Control Motor
      G04645283Courtesy of FORD MOTOR CO.
  2. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals