LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2008 >> Milan Base, 3.0 1, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 451 (HVAC Control System - F250-F550 Super Duty) >> Removal And Installation >> Blower Motor Resistor >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2006 Ford Pickup, 2006 Ford F550 Super Duty, 2006 Ford F450 Super Duty, and 2006 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the electrical connector.
    Fig 1: Locating Electrical Connector
    G04645142Courtesy of FORD MOTOR CO.
  2. Remove the screws and remove the blower motor resistor.
    Fig 2: Locating Blower Motor Resistor Screws
    G04645143Courtesy of FORD MOTOR CO.
  3. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals