LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2008 >> Milan Base, 3.0 1, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 43 (Windows And Glass -- F250-F550 Super Duty) >> Removal And Installation >> Rear Window Glass - Regulator and Motor >> Installation

Rear Window Glass - Regulator and Motor: Installation

WARNING: This page is about a different car, the 2005 Ford Pickup, 2005 Ford F550 Super Duty, 2005 Ford F450 Super Duty, and 2005 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.

    All vehicles 

    NOTE: Left side is shown, right side is similar.
    Fig 1: Installing Left Cable End Into Sliding Window
    G03925759Courtesy of FORD MOTOR CO.
  1. Install the left cable end into the sliding window trough.
  2. Install the left transition block on the cable end.
    Fig 2: Installing Left Transition Block On Cable End
    G03925746Courtesy of FORD MOTOR CO.
  3. Install the left transition block in the rear sliding window trough.
    Fig 3: Locating Rear Sliding Window Trough
    G03925737Courtesy of FORD MOTOR CO.
  4. Install the left-hand cable swag into the rear sliding window.
    Fig 4: Installing Left-Hand Cable Swag Into Rear Sliding Window
    G03925747Courtesy of FORD MOTOR CO.
  5. Repeat Steps  14 for the right side.
  6. SuperCab vehicles 

  7. Install the rear corner trim panels. For additional information, refer to INTERIOR TRIM AND ORNAMENTATION .
  8. Regular and Crew Cab vehicles 

  9. Install the rear trim panel. For additional information, refer to INTERIOR TRIM AND ORNAMENTATION .