LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2008 >> Milan Base, 3.0 1, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 405 (Evaporative Emissions - (Hybrid)) >> Removal And Installation >> Fuel Vapor Control Tube Assembly Valve >> Installation

Fuel Vapor Control Tube Assembly Valve: Installation

WARNING: This page is about a different car, the 2006 Mercury Mariner and 2006 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the fuel vapor control tube assembly valve and connect the quick connect coupling to the fuel vapor vent valve. For additional information, refer to FUEL SYSTEM-GENERAL INFORMATION .
  2. Install the fuel tank. For additional information, refer to FUEL TANK & LINES - HYBRID .
  3. Carry out a leak test. For additional information, refer to EVAPORATIVE EMISSION SYSTEM LEAK TEST .
  4. Carry out the evaporative emission repair verification drive cycle. For additional information, refer to EVAPORATIVE EMISSION REPAIR VERIFICATION DRIVE CYCLE .
scientia non olet · About LEMON Manuals