LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2008 >> Milan Base, 3.0 1, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 395 (Handles, Locks, Latches And Entry Systems) >> Removal And Installation >> Interior Door Handle - Rear >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2006 Mercury Mariner and 2006 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the rear door interior trim panel. For additional information, refer to INTERIOR TRIM AND ORNAMENTATION .
  2. Position the watershield aside.
  3. Release the interior door handle clip.
    Fig 1: Locating Interior Door Handle Clip
    G04622405Courtesy of FORD MOTOR CO.
  4. Disconnect the interior door handle cable.
    1. Release the cable conduit.
    2. Disconnect the door latch cable.
      Fig 2: Identifying Interior Door Handle Cable
      G04622406Courtesy of FORD MOTOR CO.
  5. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals