LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2008 >> Milan Base, 3.0 1, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 395 (Handles, Locks, Latches And Entry Systems) >> Removal And Installation >> Interior Door Handle - Front >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2006 Mercury Mariner and 2006 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the front door trim panel. For additional information, refer to INTERIOR TRIM AND ORNAMENTATION .
  2. Position the watershield aside.
  3. Release the interior door handle clip.
    Fig 1: Locating Interior Door Handle Clip
    G04622396Courtesy of FORD MOTOR CO.
  4. Remove the interior door handle.
    1. Disconnect the cable conduit.
    2. Disconnect the door latch cable.
      Fig 2: Identifying Interior Door Handle Cable
      G04622397Courtesy of FORD MOTOR CO.
  5. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals