LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2008 >> Milan Base, 3.0 1, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 395 (Handles, Locks, Latches And Entry Systems) >> Removal And Installation >> Exterior Front Door Handle >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2006 Mercury Mariner and 2006 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the front door trim panel. For additional information, refer to INTERIOR TRIM AND ORNAMENTATION .
  2. Position the watershield aside.
  3. Loosen the exterior door handle reinforcement screw.
    Fig 1: Locating Exterior Door Handle Reinforcement Screw
    G04622398Courtesy of FORD MOTOR CO.
  4. Remove the exterior door handle cover.
    1. Pull the exterior door handle.
    2. The front of the cover must be released prior to removing the cover.
      Fig 2: Identifying Exterior Door Handle Cover
      G04622399Courtesy of FORD MOTOR CO.
  5. Remove the exterior door handle by sliding the handle towards the rear of the vehicle.
  6. Remove the 2 exterior door handle seals.
  7. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals