LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2008 >> Milan Base, 3.0 1, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 386 (Exterior Lighting System) >> Diagnosis And Testing >> Turn Signal and Hazard Lamps >> Pinpoint Tests >> Pinpoint Test M: The Turn Signal Lamps Are Inoperative >> Normal Operation

Normal Operation

WARNING: This page is about a different car, the 2006 Mercury Mariner and 2006 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.

The smart junction box (SJB) sends reference signals to the multifunction switch through circuits 1690 (LB/RD) (LH turn input) and 1691 (LG/OG) (RH turn input). When the multifunction switch is switched to the LH or RH turn positions, the voltage signal is routed to ground through circuit 570 (BK/WH). When the SJB detects the multifunction switch is in the LH or RH turn position, the SJB sends voltage to the appropriate turn lamps.

All the turn lamps are individually wired to the SJB. The timed on/off cycle is determined in the SJB and is set to flash approximately 80 times per minute if both the front and rear turn lamps operate correctly. If only 1 turn signal lamp operates, the SJB will flash approximately 160 times per minute.

scientia non olet · About LEMON Manuals