Removal and Installation
WARNING: This page is about a different car, the 2006 Mercury Mariner and 2006 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
LH side shown; RH side similar.
- Disconnect the battery. For additional information, refer to BATTERY, MOUNTING AND CABLES .
- Open the cover, remove the screw and the interior door handle bezel.
- Remove the door handle cup screw.
- Remove the front door trim panel cover, screws and the front door trim panel.
- Disconnect the electrical connector.
- To install, reverse the removal procedure.