Removal and Installation
WARNING: This page is about a different car, the 2006 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
- With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
- Remove the transaxle rear support insulator bolt.
- To install, tighten to 80 Nm (59 lb-ft).
- Remove the 2 transaxle rear support insulator nuts.
- To install, tighten to 80 Nm (59 lb-ft).
- Remove the transaxle rear support insulator through-bolt and washer.
- To install, tighten to 115 Nm (85 lb-ft).
- Remove the transaxle rear support insulator.
- If necessary, remove the 3 bolts and the transaxle rear support insulator bracket.
- To install, tighten to 48 Nm (35 lb-ft).
- To install, reverse the removal procedure.