LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2008 >> Milan Base, 3.0 1, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 362 (HVAC Auxiliary Control System - (Hybrid)) >> Removal And Installation >> Auxiliary Temperature Blend Door Actuator >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2006 Mercury Mariner and 2006 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the auxiliary climate control housing. For additional information, refer to AUXILIARY CLIMATE CONTROL HOUSING .
  2. Remove the 3 auxiliary air inlet mode door actuator screws and the auxiliary air inlet mode door actuator.
    • Disconnect the rod.
    • To install, tighten to 2 Nm (18 lb-in).
  3. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals