LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2008 >> Milan Base, 3.0 1, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 359 (Accessory Drive System - 3.0L (4V)) >> Removal And Installation >> Accessory Drive Belt Idler Pulley >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2006 Mercury Mariner and 2006 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
  2. Remove the bolts and the RH splash shield.
    • To install, tighten to 7 Nm (62 lb-in).
  3. Using a suitable belt tensioner release tool, rotate the accessory drive belt tensioner counterclockwise and remove the accessory drive belt.
  4. Remove the bolt and the accessory drive belt idler pulley.
    • To install, tighten to 25 Nm (18 lb-ft).
    5. NOTE: Refer to Fig 1 for correct drive belt routing.
    Fig 1: Identifying Accessory Drive Belt And Pulley
    G04619624Courtesy of FORD MOTOR CO.
  5. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals