LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2008 >> Milan Base, 3.0 1, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 349 (Automatic Transmission - Cd4E) >> In-Vehicle Repair >> Transaxle Support Insulator - Lower, Rear, 3.0L DOHC >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2006 Mercury Mariner and 2006 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
  2. Remove the mount through bolt.
    • To install, tighten to 115 N.m (85 lb-ft).
  3. Remove the 1 retaining bolt and the 2 nuts for the mount and remove the mount.
    • To install, tighten to 90 N.m (66 lb-ft) (vehicles built through 10/2005).
    • To install, tighten to 80 N.m (59 lb-ft) (vehicles built after 10/2005).
  4. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals