LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2008 >> Milan Base, 3.0 1, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 347 (HVAC Control System) >> Removal And Installation >> Recirculation Blend Door Actuator >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2006 Mercury Mariner and 2006 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the instrument panel. For additional information, refer to REMOVAL AND INSTALLATION .
  2. Disconnect the recirculation vacuum control motor vacuum supply hose.
  3. Remove the 2 recirculation vacuum control motor screws.
  4. Rotate the vacuum control motor until it clears the retaining arm and remove the vacuum control motor.
    Fig 1: Identifying Vacuum Control Motor
    G04621665Courtesy of FORD MOTOR CO.
  5. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals