Removal And Installation

WARNING: This page is about a different car, the 2006 Mercury Mariner and 2006 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.

1.

Remove the engine support insulator bracket bolt.
- To install, tighten to 90 Nm (66 lb-ft).

NOTE: Failure to position the wood block and floor jack as illustrated can result in damage to the oil pan.

2.
Position a floor jack with a block of wood under the front of the oil pan.
- Using the floor jack, lift the engine 12 mm (0.47 in).

Courtesy of FORD MOTOR COMPANY

3.

Remove the nut and position the power steering pressure (PSP) tube bracket aside.
- To install, tighten to 25 Nm (18 lb-ft).

4.

Remove the 3 nuts and the engine support insulator bracket.
- To install, tighten to 55 Nm (41 lb-ft).

5.

Remove the 3 bolts and the engine support insulator.
- To install, tighten to 55 Nm (41 lb-ft) (vehicles built through 10/2005).
- To install, tighten to 48 Nm (35 lb-ft) (vehicles built after 10/2005).

6.

To install, reverse the removal procedure.