Removal and Installation

WARNING: This page is about a different car, the 2006 Mercury Mariner and 2006 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.

Remove the rear door trim panel. For additional information, refer to INTERIOR TRIM AND ORNAMENTATION .
Remove the screw and the rear door trim panel bracket.
Position the watershield aside.
Connect the window control switch electrical connector.
Using the window control switch, lower the rear door window glass to gain access to the rear door window glass screws.
Disconnect the window control switch electrical connector.
Remove the 2 rear door window glass screws.
- To install, tighten to 5 Nm (44 lb-in).
  
  Fig 1: Removing Rear Door Window Glass Screws
  Courtesy of FORD MOTOR CO.
Support the rear door window glass in the full up position.
Disconnect the rear door window motor electrical connector.
Remove the 3 rear door window regulator and motor bolts.
- To install, tighten to 6 Nm (53 lb-in).
Remove the 2 nuts and the rear door window regulator and motor.
- To install, tighten to 6 Nm (53 lb-in).
To install, reverse the removal procedure.