LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2008 >> Milan Base, 3.0 1, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 303 (Handles, Locks, Latches And Entry Systems) >> Removal And Installation >> Exterior Front Door Handle >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2006 Mercury Grand Marquis and 2006 Ford Crown Victoria. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the front door trim panel. For additional information, refer to INTERIOR TRIM AND ORNAMENTATION .
  2. Position the watershield aside.
  3. Open the clip and release the exterior door handle actuating rod.
  4. Remove the 2 rivets and the exterior door handle.
  5. To install, reverse the removal procedure.
    • Use the special tool to install the new rivets.
scientia non olet · About LEMON Manuals