LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2008 >> Milan Base, 3.0 1, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1873 (Exterior Trim & Ornamentation) >> Removal And Installation >> Beltline Moulding - Rear Door >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2011 Mercury Milan, 2011 Lincoln MKZ, and 2011 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the beltline moulding screw.
  2. Starting at the front of the moulding, pull upward to release it from the door.
  3. Pull forward to release the beltline moulding from the quarter window trim.
  4. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals