LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2008 >> Milan Base, 3.0 1, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1873 (Exterior Trim & Ornamentation) >> Removal And Installation >> Beltline Moulding - Front Door >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2011 Mercury Milan, 2011 Lincoln MKZ, and 2011 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the front door beltline moulding screw.
  2. Starting at the rear of the moulding, pull upward to release the moulding from the door.
  3. Pull rearward to remove the beltline moulding.
  4. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals