LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2008 >> Milan Base, 3.0 1, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1867 (Warning System - Side Vision & Rear Vision) >> Diagnosis And Testing >> Blind Spot Monitoring >> Pinpoint Tests >> Pinpoint Test D: DTC B11D6:11 Or DTC B11D6:15 (LED MAY ALWAYS BE ON) >> Normal Operation

Normal Operation

WARNING: This page is about a different car, the 2011 Mercury Milan, 2011 Lincoln MKZ, and 2011 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.

On each ignition cycle, the Side Obstacle Detection Control Module - Right (SOD-R) and Side Obstacle Detection Control Module - Left (SOD-L) run a self-diagnostic check during which the exterior mirror Blind Spot Information System (BLIS™)/Cross Traffic Alert (CTA) LEDs illuminate for 3 seconds then turn off indicating the system is operational. If a DTC fault is present, a system fault message is displayed in the message center.

This pinpoint test is intended to diagnose the following: