Pinpoint Test D: All Door Locks Are Inoperative From One Switch - Fusion/ MILAN
WARNING: This page is about a different car, the 2011 Mercury Milan, 2011 Lincoln MKZ, and 2011 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Use the correct probe adapter(s) when making measurements. Failure to use the correct probe adapter(s) may damage the connector.
- D1 CHECK THE DOOR LOCK CONTROL SWITCH
- Disconnect: Inoperative Door Lock Control Switch.
- Carry out the door lock control switch component test. Refer to ENGINE CONTROLS - COMPONENT TESTING -- FUSION, MILAN & MKZ (EXCEPT HYBRID) article or ENGINE CONTROLS - COMPONENT TESTING -- FUSION HYBRID, MILAN HYBRID & MKZ HYBRID article for component testing.
- Is the door lock control switch OK?
- Yes : REPAIR circuit GD126 (BK/WH) or GD139 (BK/YE) for an open. TEST the system for normal operation.
- No : INSTALL a new door lock control switch. REFER to DOOR LOCK CONTROL SWITCH . TEST the system for normal operation.