LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2008 >> Milan Base, 3.0 1, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1822 (Information System And Entertainment System) >> Removal And Installation >> Universal Serial Bus (USB) Cable and Port >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2011 Mercury Milan, 2011 Lincoln MKZ, and 2011 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the floor console. For additional information, refer to INSTRUMENT PANEL & CONSOLE -- FUSION, MILAN & MKZ article.
  2. Disconnect the Universal Serial Bus (USB) cable and port-to-bezel connector.
  3. Remove the floor console rear trim panel by pulling straight back to disengage the clips.
    4. NOTE: Be careful not to flex the floor console RH side panel too much, or damage to the floor console may occur.
  4. Remove the USB cable and port.
    • Disconnect the USB cable and port-to-Accessory Protocol Interface Module (APIM) electrical connector.
    • Carefully flex the floor console RH side panel and remove the USB cable and port.
  5. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals