LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2008 >> Milan Base, 3.0 1, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1822 (Information System And Entertainment System) >> Diagnosis And Testing >> Information and Entertainment System >> Pinpoint Tests >> Pinpoint Test AG: DTC U0155 Or DTC U0155:00 >> Pinpoint Test Ag: DTC U0155 Or DTC U0155:00

Pinpoint Test Ag: DTC U0155 Or DTC U0155:00

WARNING: This page is about a different car, the 2011 Mercury Milan, 2011 Lincoln MKZ, and 2011 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
  1. AG1 CHECK FOR LOST COMMUNICATION DTCs 
    • Ignition ON.
    • Clear continuous DTCs from all modules.
    • Ignition OFF.
    • Ignition ON.
    • Wait at least 10 seconds.
    • Retrieve all continuous DTCs from all modules.
    • Is DTC U0155 or DTC U0155:00 set in any audio system module? 
    • Yes  : GO to AG2.
    • No  : The system is operating correctly at this time. The DTC may have been set due to an intermittent fault in the network wiring.
  2. AG2 CHECK FOR BATTERY VOLTAGE OUT-OF-RANGE DTCs 
    • Carry out the self-test for the following modules:
      • ACM
      • Audio DSP module (if equipped)
      • APIM (if equipped)
      • FDIM
      • GPSM
      • IPC
    • Is DTC B1317, B1318, U3003:16, or U3003:17 recorded in any module? 
  3. AG3 CHECK FOR DTC U0155 OR DTC U0155:00 SET IN MULTIPLE MODULES 
    • Review the recorded results from the self-test.
    • Is DTC U0155 or DTC U0155:00 set in more than one audio system module? 
    • Yes  : GO to AG4.
    • No  : If there is an observable symptom, GO to SYMPTOM CHART - GENERAL AUDIO SYSTEM  to diagnose the observed symptom.

      If there is no observable symptom, CHECK the MS-CAN wiring between the SJB and the module in question for an intermittent fault.

  4. AG4 CHECK FOR CORRECT IPC OPERATION 
    • Disconnect the IPC connector.
    • Check for:
      • corrosion
      • damaged pins
      • pushed-out pins
    • Connect the IPC connector and make sure it seats correctly.
    • Is the concern still present? 
    • Yes  : INSTALL a new IPC. REFER to INSTRUMENTATION, MESSAGE CENTER & WARNING CHIMES -- FUSION, MILAN & MKZ article. CLEAR all continuous DTCs. TEST the system for normal operation.
    • No  : The system is operating correctly at this time. The concern may have been caused by a loose or corroded connector. CLEAR all continuous DTCs. REPEAT the self-test for the module(s) that set DTC U0155 or DTC U0155:00.
scientia non olet · About LEMON Manuals