Removal and Installation
WARNING: This page is about a different car, the 2011 Mercury Milan, 2011 Lincoln MKZ, and 2011 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
- With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING article.
- Remove the 4 RH front fender splash shield screws.
- Pull the RH front fender splash shield downward to access the horn.
- Disconnect the electrical connector.
- Remove the bolt and the horn.
- To install, tighten to 10 Nm (89 lb-in).
- To install, reverse the removal procedure.