Section 1791 (Charging System - High Voltage Traction Battery): Specifications
WARNING: This page is about a different car, the 2011 Mercury Milan, 2011 Lincoln MKZ, and 2011 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
MATERIAL
| Item | Specification | Fill Capacity |
|---|---|---|
| Instant Gel Adhesive TA-19 |
WSK-M2G402-A4 | - |
| Threadlock and Sealer TA-25 |
WSK-M2G351-A5 | - |
GENERAL SPECIFICATIONS
| Item | Specification |
|---|---|
| High Voltage Traction Battery | |
| Battery chemistry | Nickel metal hydride |
| Battery system capacity | 5.5 amp-hours |
| Standard voltage | 275 volts |
| Low Voltage Battery | |
| Voltage | 12 volts |
TORQUE SPECIFICATIONS
| Description | Nm | lb-ft | lb-in |
|---|---|---|---|
| A/C compressor manifold and suction tube fitting nut | 15 | - | 133 |
| A/C evaporator inlet fitting nut | 15 | - | 133 |
| Battery Energy Control Module (BECM) nuts | 9 | - | 80 |
| Battery Pack Sensor Module (BPSM) nuts | 9 | - | 80 |
| High-voltage Bussed Electrical Center (BEC) cover nuts | 9 | - | 80 |
| High-voltage BEC cover screws | 9 | - | 80 |
| High-voltage BEC nut | 9 | - | 80 |
| High-voltage cable shield nuts | 9 | - | 80 |
| High-voltage cable strain relief bolt | 9 | - | 80 |
| High-voltage cable connector and bracket assembly nuts | 9 | - | 80 |
| High-voltage cable connector and bracket assembly screw | 6 | - | 53 |
| High-voltage/high-current positive cable nut | 15 | - | 133 |
| High-voltage/high- and low-current negative cable nut | 15 | - | 133 |
| High-voltage/low-current cable nuts | 4 | - | 35 |
| High Voltage Traction Battery (HVTB) cable nuts | 15 | - | 133 |
| HVTB cooling inlet duct nuts | 6 | - | 53 |
| HVTB ground strap-to-chassis bolt | 12 | - | 106 |
| HVTB mounting bolts | 20 | - | 177 |
| Hydraulic Control Unit (HCU) bracket bolts | 23 | 17 | - |