Removal & Installation
WARNING: This page is about a different car, the 2010 Lincoln Town Car. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the fuel tank. For additional information, refer to REMOVAL & INSTALLATION article.
- Disconnect the Fuel Tank Pressure (FTP) sensor electrical connector.
- Disconnect the 4 fuel vapor tube assembly retainer clips from the fuel tank.
- Remove and discard the fuel vapor tube assembly clamp.
- Install a new crimp-style clamp during installation.
- Remove the grade vent valve from the fuel tank.
- Remove the fuel vapor tube assembly from the fuel tank.
- To install, reverse the removal procedure.
- Carry out the Evaporative Emission System Leak Test. For additional information, refer to Evaporative Emission System Leak Test .
NOTE:
Be careful when removing the grade vent valve from the fuel tank grommet to avoid damaging either component.
NOTE:
Lubricate the grade vent valve grommet with clean engine oil.