Removal And Installation
WARNING: This page is about a different car, the 2010 Lincoln Town Car. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the 2 pin-type retainers and the scuff plate.
- Disconnect the 2 luggage compartment lid closing motor electrical connectors.
- Remove the 3 bolts and the luggage compartment lid closing motor.
- To install, tighten to 10 Nm (89 lb-in).
- To install, reverse the removal procedure.
- Carry out the initialization procedure. For additional information, refer to Luggage Compartment Lid Motor Initialization .