LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2008 >> Milan Base, 3.0 1, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1708 (Accessory Drive System) >> Removal & Installation >> Accessory Drive Belt Tensioner >> Installation

Accessory Drive Belt Tensioner: Installation

WARNING: This page is about a different car, the 2010 Lincoln Town Car. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the accessory drive belt tensioner.

    Tighten the bolt in 2 stages:

    • Stage 1: Tighten to 10 N.m (89 lb-in).
    • Stage 2: Tighten an additional 90 degrees.
    2. Fig 1: Accessory Drive Belt Tensioner
    GF0013749Courtesy of FORD MOTOR CO.
  2. Install the accessory drive belt. For additional information, refer to ACCESSORY DRIVE BELT .
scientia non olet · About LEMON Manuals