LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2008 >> Milan Base, 3.0 1, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1708 (Accessory Drive System) >> Removal & Installation >> Accessory Drive Belt Idler Pulley >> Removal & Installation

Removal & Installation

WARNING: This page is about a different car, the 2010 Lincoln Town Car. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the accessory drive belt. For additional information, refer to ACCESSORY DRIVE BELT .
  2. Remove the bolt and the accessory drive belt idler pulley.
    • To install, tighten to 25 Nm (18 lb-ft).
    3. Fig 1: Accessory Drive Belt Idler Pulley
    GF0013750Courtesy of FORD MOTOR CO.
  3. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals