LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2008 >> Milan Base, 3.0 1, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1558 (Exterior Trim & Ornamentation) >> Removal And Installation >> Beltline Molding - Rear Door >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2010 Mercury Milan, 2010 Lincoln MKZ, and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the beltline molding screw.
  2. Starting at the front of the molding, pull upward to release it from the door.
  3. Pull forward to release the beltline molding from the quarter window trim.
  4. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals