LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2008 >> Milan Base, 3.0 1, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1558 (Exterior Trim & Ornamentation) >> Removal And Installation >> Beltline Molding - Front Door >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2010 Mercury Milan, 2010 Lincoln MKZ, and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the front door beltline molding screw.
  2. Starting at the rear of the molding, pull upward to release the molding from the door.
  3. Pull rearward to remove the beltline molding.
  4. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals