Removal and Installation

WARNING: This page is about a different car, the 2010 Mercury Milan, 2010 Lincoln MKZ, and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.

All vehicles

Remove the rear door inside handle bolt cover.
Remove the upper rear door inside handle bolt.
Fusion and Milan
Remove the rear door handle screw cover.
Remove the rear door handle screw.
Remove the rear door inside handle bezel.
- Lift upward on the rear of the rear door inside handle bezel.
- Disconnect the electrical connector.
All vehicles
Remove the rear door trim panel upper screw.
MKZ
Remove the rear door trim panel lower screw.
All vehicles
Remove the rear door trim panel.
NOTE: The back of the rear door trim panel shown in illustration with the location of the rear door trim panel pin-type retainers indicated.
- Pull the rear door trim panel outward to release the rear door trim panel pin-type retainers.
Fig 1: Exploded View Of Rear Door Trim Panel Electrical Connector
Courtesy of FORD MOTOR CO.
To install, reverse the removal procedure.