LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2008 >> Milan Base, 3.0 1, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1538 (Evaporative Emissions System (Except Hybrid)) >> Removal And Installation >> Evaporative Emission Canister Purge Valve >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2010 Mercury Milan, 2010 Lincoln MKZ, and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
WARNING: Do not smoke, carry lighted tobacco or have an open flame of any type when working on or near any fuel-related component. Highly flammable mixtures are always present and may be ignited. Failure to follow these instructions may result in serious personal injury.
WARNING: Do not carry personal electronic devices such as cell phones, pagers or audio equipment of any type when working on or near any fuel-related component. Highly flammable mixtures are always present and may be ignited. Failure to follow these instructions may result in serious personal injury.
WARNING: Always disconnect the battery ground cable at the battery when working on an evaporative emission (EVAP) system or fuel-related component. Highly flammable mixtures are always present and may be ignited. Failure to follow these instructions may result in serious personal injury.

All vehicles 

  1. Disconnect the battery ground cable. For additional information, refer to REMOVAL AND INSTALLATION (2.5L), REMOVAL AND INSTALLATION (3.0L) and REMOVAL AND INSTALLATION (3.5L) .

    2.5L and 3.0L vehicles 

  2. Disconnect the Evaporative Emission (EVAP) canister purge valve electrical connector.
  3. Disconnect the vapor tube-to-EVAP  canister purge valve quick connect coupling. For additional information, refer to QUICK CONNECT COUPLING .
  4. Remove the 2 bolts and the EVAP  canister purge valve.
    • To install, tighten to 10 Nm (89 lb-in).

    3.5L vehicles 

  5. Remove the lower cowl panel grille. For additional information, refer to COWL PANEL GRILLE .
    NOTE: The lower cowl panel grille must be removed to access the EVAP  canister purge valve.
  6. Disconnect the EVAP  canister purge valve electrical connector.
  7. Disconnect the 2 vapor tube-to- EVAP  canister purge valve quick connect couplings. For additional information, refer to QUICK CONNECT COUPLING .
  8. Depress the tab and remove the EVAP  canister purge valve from the bracket.
    Fig 1: Removing EVAP Canister Purge Valve From Bracket
    G06272528Courtesy of FORD MOTOR CO.

    All vehicles 

  9. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals