LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2008 >> Milan Base, 3.0 1, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1531 (Accessory Drive System - 2.5L (Hybrid)) >> Removal And Installation >> Accessory Drive Belt Tensioner >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2010 Mercury Milan and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
  1. Depower the vehicle high voltage electrical system. For additional information, refer to REMOVAL AND INSTALLATION .
  2. Remove the 4 screws and position the RH fender splash shield aside.
    Fig 1: Locating RH Fender Splash Shield Screws
    G06257214Courtesy of FORD MOTOR CO.
  3. Remove the 6 pin-type retainers and the RH splash shield.
    NOTE: RH front wheel and tire are removed for clarity.
    Fig 2: Locating RH Splash Shield Pin-Type Retainers
    G06272553Courtesy of FORD MOTOR CO.
  4. Remove the A/C hose retainer bracket bolt.
    • To install, tighten to 6 Nm (53 lb-in).
    Fig 3: Locating A/C Hose Retainer Bracket Bolt
    G06272454Courtesy of FORD MOTOR CO.
  5. Rotate the accessory drive belt tensioner counterclockwise and remove the accessory drive belt from the tensioner pulley.
  6. Disconnect the 2 vehicle high voltage electrical system electrical connectors.
  7. Detach the vehicle high voltage electrical system electrical connector retainer from the accessory drive belt tensioner.
  8. Remove the 3 bolts and the accessory drive belt tensioner.
    • To install, tighten to 25 Nm (18 lb-ft).
    NOTE: The accessory drive belt tensioner must be replaced as a complete unit.
  9. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals