LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2008 >> Milan Base, 3.0 1, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 153 (Accessory Drive System) >> Removal And Installation >> Accessory Drive Belt Tensioner >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2005 Mercury Montego, 2005 Ford Freestyle, and 2005 Ford Five Hundred. However, it is still accessible from the selected car via links, so may be relevant.

    All vehicles 

  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
  2. Remove the 7 pin-type retainers and the RH splash shield.

    3. Freestyle only 

  3. If equipped, remove the 3 A/C compressor pulley shield retainers and the shield.

    4. All vehicles 

  4. Using a suitable belt tensioner release tool, rotate the accessory drive belt tensioner counterclockwise and remove the accessory drive belt.
  5. Remove the bolt and the accessory drive belt tensioner.
    • To install, tighten to 45 Nm (33 lb-ft).
  6. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals