LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2008 >> Milan Base, 3.0 1, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1507 (HVAC - Climate Control System) >> Removal And Installation >> Temperature Blend Door Actuator - RH, Dual-Zone EATC >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2010 Mercury Milan, 2010 Lincoln MKZ, and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the passenger air bag module. For additional information, refer to REMOVAL .
  2. Disconnect the RH temperature blend door actuator electrical connector.
  3. Remove the 2 RH temperature blend door actuator bracket screws.
  4. Detach the wire harness from the RH temperature blend door actuator bracket.
  5. Remove the RH temperature blend door actuator.
  6. To install, reverse the removal procedure.
  7. Remove the Smart Junction Box (SJB) fuse 15 for at least one minute.
    NOTE: The purpose of the module actuator position calibration is to allow the HVAC module to reinitialize and calibrate the actuator stop points. To carry out calibration, carry out the following steps.
    8. NOTE: When the ignition switch is switched to the ON position, the HVAC module will initialize and calibrate the actuators. Calibration of the actuators will take approximately 30 seconds.
  8. Reinstall SJB  fuse 15. Turn the ignition switch to the ON position and wait 30 seconds before verifying correct DEFROST/PANEL/FLOOR operation.
scientia non olet · About LEMON Manuals