LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2008 >> Milan Base, 3.0 1, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1504 (Information System And Entertainment System) >> Removal And Installation >> Universal Serial Bus (USB) Cable and Port >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2010 Mercury Milan, 2010 Lincoln MKZ, and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the floor console. For additional information, refer to INSTRUMENT PANEL AND CONSOLE .
  2. Disconnect the Universal Serial Bus (USB) cable and port-to-bezel connector.
  3. Remove the floor console rear trim panel by pulling straight back to disengage the clips.
  4. Remove the USB cable and port.
    NOTE: Be careful not to flex the floor console RH side panel too much, or damage to the floor console may occur.
    • Disconnect the USB  cable and port-to-Accessory Protocol Interface Module (APIM) electrical connector.
    • Carefully flex the floor console RH side panel and remove the USB  cable and port.
  5. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals