LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2008 >> Milan Base, 3.0 1, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1504 (Information System And Entertainment System) >> Removal And Installation >> Speaker - Door >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2010 Mercury Milan, 2010 Lincoln MKZ, and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.

All speakers 

  1. Remove the door trim panel. For additional information, refer to INTERIOR TRIM AND ORNAMENTATION .

    Front door tweeter speaker (Fusion and Milan) 

  2. Remove the sail panel.
    • Disconnect the electrical connector.
  3. Remove the 2 screws and the front door tweeter speaker from the sail panel.
    Fig 1: Locating Front Door Tweeter Speaker Screws
    G06263202Courtesy of FORD MOTOR CO.

    Front door tweeter speaker (MKZ) 

  4. Remove the 2 nuts and the front door tweeter speaker from the door trim panel.
    Fig 2: Locating Front Door Tweeter Speaker Nuts
    G06263203Courtesy of FORD MOTOR CO.

    Front or rear door speaker 

  5. Remove the 4 screws and the door speaker.
    • Disconnect the electrical connectors.

      All speakers 

  6. To install, reverse the removal procedure.