LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2008 >> Milan Base, 3.0 1, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1485 (Information Center - Instrumentation, Message Center And Warning Chimes) >> Diagnosis And Testing >> Instrumentation, Message Center and Warning Chimes >> Pinpoint Tests >> Pinpoint Test AE: The Malfunction Indicator Lamp (MIL) Is Never/Always On >> Pinpoint Test AE: The Mil Is Never/Always On

Pinpoint Test AE: The Mil Is Never/Always On

WARNING: This page is about a different car, the 2010 Mercury Milan, 2010 Lincoln MKZ, and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
  1. AE1 CARRY OUT THE IPC WARNING LAMPS AND CHIME ACTIVE COMMAND USING THE SCAN TOOL 
    • Ignition ON.
    • Enter the following diagnostic mode on the scan tool: IPC  DataLogger.
    • Select the IPC MIL  (MIL_LAMP) active command. Command the MIL  on and off while observing the MIL  .
    • Does the MIL illuminate when selected on, and turn off when selected off? 
  2. AE2 RETRIEVE THE RECORDED DTCs FROM THE PCM KOEO SELF-TEST 
    • Check for recorded PCM DTCs from the Key ON Engine OFF (KOEO) self-test.
    • Are any DTCs recorded? 
  3. AE3 RETRIEVE THE RECORDED DTCs FROM THE IPC SELF-TEST 
    • Check for recorded DTCs from the IPC  self-test.
    • Are any DTCs recorded? 
    • Yes  : For DTC U0100:00, Go To PINPOINT TEST BF .

      For all other DTCs, REFER to DTC TABLES .

    • No  : INSTALL a new PCM. REFER to Refer to the appropriate Electronic Engine Controls article for the procedure. TEST the system for normal operation.
scientia non olet · About LEMON Manuals