DTC C200C: Steering Shaft Torque Sensor 2: Description

WARNING: This page is about a different car, the 2010 Mercury Milan, 2010 Lincoln MKZ, and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.

The PSCM continually monitors the steering shaft torque sensor when the ignition is ON and the voltage supply to the PSCM is above 6 volts.

DTC C200C:2F (Steering Shaft Torque Sensor 2: Signal Erratic) - If the steering shaft torque sensor signal is outside the expected range, then DTC C200C:2F will be set.