DTC C200B: Steering Shaft Torque Sensor 1: Description
WARNING: This page is about a different car, the 2010 Mercury Milan, 2010 Lincoln MKZ, and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
The PSCM continually monitors the steering shaft torque sensor when the ignition is ON and the voltage supply to the PSCM is above 6 volts.
- DTC C200B:2F (Steering Shaft Torque Sensor 1: Signal Erratic) - If the steering shaft torque sensor signal is outside the expected range, then DTC C200B:2F will be set.
- DTC C200B:61 (Steering Shaft Torque Sensor 1: Signal Calculation Failure) - If the steering shaft torque sensor signal is not within a certain threshold, then DTC C200B:61 will be set.
- DTC C200B:62 (Steering Shaft Torque Sensor 1: Signal Compare Failure) - If the steering shaft torque sensor signal does not match other sensor input, then DTC C200B:62 will be set.