LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2008 >> Milan Base, 3.0 1, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1471 (Accessory Drive System - 3.5L) >> Removal And Installation >> Accessory Drive Belt >> Installation

Accessory Drive Belt: Installation

WARNING: This page is about a different car, the 2010 Lincoln MKZ and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
  1. Working from under the vehicle, position the accessory drive belt on all pulleys, with the exception of the generator pulley.
  2. Working from the top of the vehicle, rotate the accessory drive belt tensioner clockwise and install the accessory drive belt on the generator pulley.
    NOTE: After installation, make sure the accessory drive belt is correctly seated on all pulleys.
  3. Install the RH splash shield and the 6 pin-type retainers.
  4. Position the RH fender splash shield and install the 4 screws.
    Fig 1: Locating RH Fender Splash Shield Screws
    G06257214Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals