LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2008 >> Milan Base, 3.0 1, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1454 (Automatic Transaxle - 6F35) >> In-Vehicle Repair >> Transaxle Support Insulator - 2.5L >> Installation

Transaxle Support Insulator - 2.5L: Installation

WARNING: This page is about a different car, the 2010 Mercury Milan and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
  1. Clean the transaxle support insulator frame bolts using a wire brush and apply new threadlock to the threads.
  2. Position the transaxle support insulator in place and install the upper 2 transaxle support insulator bolts.
    • Tighten to 62 Nm (46 lb-ft).
    Fig 1: Locating Top Transaxle Support Insulator Bolts
    G06278600Courtesy of FORD MOTOR CO.
  3. Install the lower 2 transaxle support insulator bolts.
    • Tighten to 62 Nm (46 lb-ft).
    Fig 2: Locating Lower Transaxle Support Insulator Bolts
    G06278601Courtesy of FORD MOTOR CO.
  4. Position the LH front structure-to-subframe splash shield in place and install the 6 pin-type retainers.
    Fig 3: Locating LH Front Structure-To-Subframe Splash Shield And Pin-Type Retainers
    G06278602Courtesy of FORD MOTOR CO.
  5. Position the LH splash shield in place and install the 4 screws.
    Fig 4: Locating LH Splash Shield And Screws
    G06278603Courtesy of FORD MOTOR CO.
  6. Position the BJB  and bracket in place and install the 2 bolts and the nut.
    • Tighten to 10 Nm (89 lb-in).
    Fig 5: Locating Bolts And Nut
    G06278604Courtesy of FORD MOTOR CO.
  7. Install the electrical connector bracket on the BJB  .
    Fig 6: Locating Electrical Connector Bracket
    G06278605Courtesy of FORD MOTOR CO.
  8. Connect the wiring harness retainer on the LH shock tower.
    Fig 7: Locating Wiring Harness Retainer
    G06278606Courtesy of FORD MOTOR CO.
  9. Position the wiring harness in place and install the retainer on the transaxle support insulator.
    Fig 8: Locating Wiring Harness
    G06278607Courtesy of FORD MOTOR CO.
  10. Install the through bolt.
    • Tighten to 150 Nm (111 lb-ft).
    Fig 9: Locating Through Bolt
    G06278608Courtesy of FORD MOTOR CO.
  11. Remove the Engine Support Bar.
    Fig 10: Identifying Engine Support Bar
    G06278609Courtesy of FORD MOTOR CO.
  12. Install the battery and battery tray. For additional information, refer to BATTERY, MOUNTING AND CABLES .
  13. Install the ACL  and the outlet pipe. For additional information, refer to INTAKE AIR DISTRIBUTION & FILTERING - 2.5L .
scientia non olet · About LEMON Manuals