LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2008 >> Milan Base, 3.0 1, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 108 (Information Center -- F250-F550 Super Duty) >> Diagnosis And Testing >> Information And Message Center >> Pinpoint Tests >> Pinpoint Test F: The Door Ajar Display Is Never/Always On

Pinpoint Test F: The Door Ajar Display Is Never/Always On

WARNING: This page is about a different car, the 2005 Ford Pickup, 2005 Ford F550 Super Duty, 2005 Ford F450 Super Duty, and 2005 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. F1 CHECK THE INTERIOR LAMPS OPERATION 
    • Open and close each door while monitoring the interior lamps.
    • Do the interior lamps operate correctly ? 
    • Yes  : GO to F2.
    • No  : REFER to INTERIOR LIGHTING to continue diagnosis of the interior lamps.
  2. F2 CHECK FOR CORRECT INSTRUMENT CLUSTER OPERATION 
    • Disconnect all the instrument cluster connectors.
    • Check for:
      • corrosion
      • pushed-out pins
    • Connect all the instrument cluster connectors and make sure they seat correctly.
    • Operate the system and verify the concern is still present.
    • Is the concern still present? 
    • Yes  : INSTALL a new instrument cluster. REFER to INSTRUMENT CLUSTER . TEST the system for normal operation.
    • No  : The system is operating correctly at this time. The concern may have been caused by a loose or corroded connector.
scientia non olet · About LEMON Manuals