LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2008 >> Milan Base, 3.0 1, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1063 (Front Disc Brake System) >> Removal And Installation >> Front Disc Brake - Hybrid >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2008 Mercury Mariner and 2008 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: The following steps must be followed to prevent the accumulator from charging and pressurizing the brake system.
  1. Disconnect the battery. For additional information, refer to BATTERY, MOUNTING AND CABLES article.
  2. Remove the battery junction box (BJB) fuses 9 (50A) and 18 (50A).
  3. Remove the brake caliper anchor plate. For additional information, refer to Brake Caliper Anchor Plate .
  4. Remove the brake disc.
  5. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals