LEMON Manuals: Even more car manuals for everyone
Home >> Mercury >> 2008 >> Milan Base, 3.0 1, FWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1038 (Electronic Engine Control System - 2.3L - (Except Hybrid)) >> Removal And Installation >> Mass Air Flow (MAF) Sensor >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2008 Mercury Mariner and 2008 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the Mass Air Flow (MAF) sensor electrical connector.
  2. Remove the 2 screws and the MAF sensor.
    • To install, tighten to 10 Nm (89 lb-in).
  3. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals